Flow time out issues

(0) Share

Report

Posted on by powerdevkris

159 Season of Giving Solutions 2025

Hi,

My flow is always hitting a timeout issue.

i have a power bi report inside the condition action. What i did is set the timeout to the settings below since i knew this was the only one running long within the flow

But its still showing an error for flow time outs. Anything that i need to check further to handle the time out errors?

Categories:

Building flows

I have the same question (0)

All responses (2)

Answers (0)

Sort by

Ellis Karim 12,146 Super User 2026 Season 1 on at

Like
a
(1)

Report
Copy link

Link copied!

You can add a parallel branch to handle the condition when a timeout occurs. Then terminate the flow with a successful termination.

For example:

Add a parallel branch after your action (this example uses an Approval action):

Then configure the run after settings for this branch to handle the situation where the previous action (Approval action) times out:

Tick the "has timed out" box:

Hope this helps.

Ellis
____________________________________
If I have answered your question, please mark the post as ☑️ Solved.
If you like my response, please give it a 👍🏼 Thumbs Up.
My Blog Site | Twitter | LinkedIn

Was this reply helpful? Yes No
powerdevkris 159 Season of Giving Solutions 2025 on at

Like
a
(0)

Report
Copy link

Link copied!

Thanks for the feedback! What i noticed is the flow is timing out when running it inside the flow. But when I ran it outside. It will just push through without timing out.

Was this reply helpful? Yes No