Unanswered

ERP Connector and Power Automate

(1) Share

Report

Posted on by Jagravi_Trivedi

If We want to create Power automate flow which will have ERP connector block used to call function /RFC. If we want to deploy and run this on remote machine, what pre - requisites is required on Virtual Machine.

connector package and On - premises data gate way where we need to install this on local system or remote system where we want to deploy bots.

Categories:

Using connectors

I have the same question (0)

All responses (2)

Answers (0)

scottwoodall Microsoft Employee on at

Like (1)

Report

I think this was accidentally double posted. My response in the other thread can be found here.

Was this reply helpful? Yes No
CU07101144-0 2 on at

Like (1)

Report

To create a Power Automate flow that utilizes an ERP connector block to call a function or RFC, there are several prerequisites you'll need to ensure are in place on your virtual machine.

First, you'll need to install the On-Premises Data Gateway on the remote machine where you plan to deploy your bots. This gateway acts as a bridge between your on-premises data sources and the cloud services in Power Automate. Additionally, ensure that the connector package for your specific ERP system, like Odoo, is properly installed and configured. This setup is crucial for enabling seamless communication between Power Automate and your ERP system.

Make sure that your virtual machine has the necessary network configurations to allow communication between the gateway and your ERP system. This includes proper firewall settings and network permissions.

Once these prerequisites are met, you should be able to deploy and run your Power Automate flows effectively. If you encounter any issues, double-check your configurations and consider consulting the documentation for both Power Automate and your specific ERP system for further troubleshooting tips.

Was this reply helpful? Yes No