Unanswered

Version history doesn’t appear in Power Automate (flow inside a Solution)

(0) Share

Report

Posted on by MG-24021958-0

Hi everyone,

I’m having an issue with Power Automate where Version history is not showing for a cloud flow, even though the flow is inside a Solution.

What I’m seeing

The “Version history” panel opens, but it’s empty (no versions listed).
The flow runs normally and I can see Run history without problems.

Environment / setup

Cloud flow in Power Automate (make.powerautomate.com)
Flow is included in a Solution
I’m using the new designer, but I also tried switching it off / using different browsers and an InPrivate window.

Troubleshooting already tried

Turning off the new designer and refreshing
Opening the flow from the flow details page (not from inside the editor)
Clearing cache / using InPrivate / using another browser
Confirming I have access to the environment and can edit the flow

Has anyone run into this before? Is there a known limitation or admin setting that can hide Version history for flows in Solutions (or in certain environments/tenants)? Any suggestions on where else to check for the version list would be appreciated.

Thanks!

Categories:

Using flows

I have the same question (0)

All responses (3)

Answers (0)

Expiscornovus 33,830 Most Valuable Professional on at

Like (0)

Report
Copy link

Link copied!

Hi @MG-24021958-0,

Just tried to reproduce your issue with a flow inside a solution. Works fine in my development environment.

So, in order to found the root cause of your issue we might need a bit more information. You are using Portuguese language settings correct? Does it happen when you are using English settings?

Can you open the developer toolbar and have a look in the Console and Network tabs? See if you can spot any errors in there (HTTP 400/500/etc.).

Happy to help out 😁

I share more #PowerAutomate and #SharePointOnline content on my Blog, LinkedIn, Bluesky profile or Youtube Channel

Was this reply helpful? Yes No
MG-24021958-0 2 on at

Like (0)

Report
Copy link

Link copied!

Hi @Expiscornovus,

Thanks for checking.

I haven’t switched the environment language to English yet, because doing so would require me to recreate all my connectors, so I preferred not to change it at this moment.

However, I did open the developer tools and captured a screenshot of the Console and Network tabs (attached). Could you please take a look and let me know if anything stands out, or if you have any suggestions on what I should check next?

Was this reply helpful? Yes No
Expiscornovus 33,830 Most Valuable Professional on at

Like (0)

Report
Copy link

Link copied!

Hi @MG-24021958-0,

It looks like it is failing to load several resources from your Power Platform environment. I see a lot of 404s (not found) and 403s (forbidden) and also one 400 (bad request). So, this might be a bug you are experiencing.

Might be a good case for Power Automate support. My suggestion would be to reach out to them (in parallel to this thread):

https://www.microsoft.com/en-us/power-platform/products/power-automate/support

Happy to help out 😁

I share more #PowerAutomate and #SharePointOnline content on my Blog, LinkedIn, Bluesky profile or Youtube Channel

Was this reply helpful? Yes No