Unanswered

Cannost sign in to Azure DevOps

(0) Share

Report

Posted on by tyna

Hello,

I would like to integrate Azure DevOps with Outlook - whenever an e-mail comes to a specific address, a new work item is created.

However, I cannot sign in to Azure DevOps from Microsoft Flow. I keep getting this error message:

{"Message":"Redirect URI (https://europe-001.consent.azure-apim.net/redirect?error=InvalidScope) did not receive an expected state query parameter from the authorization service (Referer: https://emea.flow.microsoft.com/cs-cz/galleries/public/templates/d2e0a690ab4511e68a67d1ddef3fa7c0/při-přijetí-e-mailu-vytvořit-problém-ve-visual-studio-team-services/)."}

Categories:

Using connectors

I have the same question (0)

All responses (3)

Answers (0)

v-bacao-msft on at

Like (0)

Report

Hi @tyna,

I did a test on my side, I can create a connection to Azure DevOps connector, and I can configure and use the relevant action.

You could use the account to log in to Azure DevOps portal in browser to check if the account can log in.

Then try to reconfigure the connection.

Also refer to the conditions required to use the Azure DevOps connector to check if these conditions are met:

https://docs.microsoft.com/en-us/connectors/visualstudioteamservices/#createworkitem

Please take a try again.

Best Regards,

Was this reply helpful? Yes No
tyna 4 on at

Like (0)

Report

Hi,

I use the same browser to log in to Azure DevOps and it works just fine. However, I keep getting the same error message. Is there anything else I can try?

Kristýna

Was this reply helpful? Yes No
tyna 4 on at

Like (0)

Report

Hello,

could You please take a look at this again?

Thanks,

Kristýna

Was this reply helpful? Yes No