You’re offline. This is a read only version of the page.
8
I have 2 messages - OK and Good. I want a delay of 5 seconds between both these messages. Through the documentation I found there is a delay activity in the PVA, However I have not been able to make it work whatever I try. Every time both the messages are being sent one after the other without any delay.
Documentation Reference Link - Sending event activities - Power Virtual Agents | Microsoft Learn
I'm wondering the same thing. Adding delay between two messages doesnt add delay between two messages. It delays the reply altogether, and then throws out the two messages at the same time. Such a basic feature, but I can't seem to figure it out.
#1
Romain The Low-Code...
25
#1
Pablo Roldan
25
#3
stampcoin
10
Share
Report
All responses (
Answers (
