Announcements
I am building a custom connector with OpenAPI file. In the custom connector wizard I can see 5 actions.
However in Power Automate studio, when I add an action for this connector, there is only 2 actions available. What have I missed?
Same when you look at the Swagger code?
My Swagger code have all the 5 actions at the beginning. After import first time, there is 5 actions listed in custom connector interface.
However in Power Automate there are only 2.
Thank you for your reply.
I press Update and there is no change.
But I notice the "visibility" is set to "none" for some actions. So I changed all 5 actions to "important". Now all actions are disappear from Power Automate GUI.
I guess my swagger code have some issue on x-ms-visibility field. I will look into it. Thanks.
I had the same problem, but when I reduce the length of the Action Operation ID all the actions were shown in Power Automate.
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
Congratulations to our 2026 Super Users!
Congratulations to our 2025 community superstars!
These are the community rock stars!
Stay up to date on forum activity by subscribing.
Haque 516
Valantis 477
Vish WR 470
