Hello all
I have been facing a problem that when a button is clicked the commands do not fully run.
So I've built a PowerApp (source is sharepoint) and it has been used/ is being used by various users for more than a year and around 99% of the time it works without any problem, but, sometimes, and I still couldn't figure out why, it only completes half of the commands in the OnSelect of a button. I can never replicate the issue that occurs because when I try it works as intended and even the user tries doing the same thing again it works, and the only thing I know that is different from me and the users is that they are sometimes in places where the internet is very weak, could that be a problem? But if it would be a problem why would it do half of the commands and not the other half?
I've looked to check if something might be different in the source that could affect it but couldn't find anything.
It is not a particullar button as well, I do have a few buttons in the App for the various functionalities and all seem to present the same problem from time to time
Has anyone ever had a similar problem with this?
Best regards,
