Unanswered

Please Help me With the Refresh time zone

(0) Share

Report

Posted on by PC-03010626-0

please help me i have big problem about timezone refresh

I have been create the flow for refresh data in power by that trigger every 15 min and i already set it to UTC + 7 but on the API its still show

and it cause problem to power bi that the data is freeze after midnight till 7.00 UTC

flow trigger at correct timezone

but inside the API refresh is

please help me thankyou inadvance

Best Regard

Pitchaya C

Categories:

Building flows

I have the same question (0)

All responses (4)

Answers (0)

Sort by

David_MA 15,079 Super User 2026 Season 1 on at

Like
a
(1)

Report
Copy link

Link copied!

From the flow history and the configuration, the flow is running exactly as scheduled. The start time in the initial setup determines when the first run will begin, which you set for December 24, 2024, at midnight in your specified time zone. After that, it runs every 15 minutes. However, due to how jobs are scheduled, there can be slight variations, so it might not run exactly at :00, :15, :30, and :45 each hour.

The time zone and start date are only used for the initial start trigger. After that, the flow runs based on UTC time at the specified interval (every 15 minutes), making the time zone irrelevant for subsequent runs. Every 15 minutes is the same no matter what time zone you are in.

Would you prefer the flow to run at a specific time each day instead of every 15 minutes?

Was this reply helpful? Yes No
PC-03010626-0 4 on at

Like
a
(0)

Report
Copy link

Link copied!

Hi David_MA i would like this flow to trigger every 15 minute everyday , and i want to set time zone to UTC+7

but when i run flow its GMT as in picture

and this cause data to freeze after midnight till 7.00

Was this reply helpful? Yes No
David_MA 15,079 Super User 2026 Season 1 on at

Like
a
(1)

Report
Copy link

Link copied!

So did my prior post answer your question as I don't understand your second post. Your flow is already set up and scheduled to run every fifteen minutes. You don't need to do anything else. The time zone is only used for the first run of the flow. After that, it doesn't matter. Every 15 minutes is the same in every time zone. And I don't know what you mean by, "and this cause data to freeze after midnight till 7.00".

If for some reason you need to convert the run time to your time zone, just use an expression such as convertTimeZone(utcNow(), 'UTC', 'SE Asia Standard Time') to do so. Replace utcNow() with the date from the trigger.

If you don't want it to run it at a certain time, you would need to change the frequency to Day and then specify the hours and minutes you want it to run. This is explained here: Power Automate: Recurrence Trigger - Manuel T. Gomes

Was this reply helpful? Yes No
PC-03010626-0 4 on at

Like
a
(0)

Report
Copy link

Link copied!

Here is the problem that i to explain Sir

the above problem ends at 7.00 am in my timezone (UTC+7)

Was this reply helpful? Yes No