Answered

Common Data Service (current environment) connector question

(0) Share

Report

Posted on by Robert Rybaric

Hi, can someone please point me to the right direction?

I am using the Common Data Service (current environment) connector as a trigger, which should trigger by create, update and delete events for a CDS entity. The question is, where can be found, which if these 3 events has actually triggered the flow.

Thanks!

Robert Rybaric

Categories:

Using connectors

I have the same question (0)

All responses (5)

Answers (1)

Mira Ghaly 11,413 Moderator on at

Like (0)

Report

@Robert_Rybaric
You can check this from the flow run history - open the specific run and open the trigger step

Was this reply helpful? Yes No
Robert Rybaric 52 on at

Like (0)

Report

Sorry, maybe I was not clear enough - I need to figure out the triggering event within the flow itself to be able to decide about the business logic.

Was this reply helpful? Yes No
Verified answer

Mira Ghaly 11,413 Moderator on at

Like (0)

Report

Hi @Robert_Rybaric
You can get it from the trigger output as below
Use Data Operations - Compose: as below
triggerOutputs()?['body']['sdkmessage']

If this solves your problem , Please Mark as an Accepted solution. Thanks

Was this reply helpful? Yes No
Robert Rybaric 52 on at

Like (0)

Report

Thanks, that is the exactly what I was looking for. But now I am facing another issue. When the flow triggers based on Delete event, there are no values in the deleted record's fields dynamic content. Is it a standard behavior, that the record field values are not available for the delete event?

Was this reply helpful? Yes No
Mira Ghaly 11,413 Moderator on at

Like (0)

Report

@Robert_Rybaric
Yes this is the default behaviour because flows execute in asynchronous mode so you can't capture the data of the deleted record, in case you want to capture this data you need a plugin that runs on the delete message and use the preimage to get the deleted record.

Was this reply helpful? Yes No