web
You’re offline. This is a read only version of the page.
close
Skip to main content

Notifications

Announcements

Community site session details

Community site session details

Session Id :
Power Platform Community / Forums / Power Automate / Desktop process stops ...
Power Automate
Unanswered

Desktop process stops different functions - no error

(0) ShareShare
ReportReport
Posted on by 18

I have a PAD process that seemingly unprovokede stops in different places. It reports no errors whatsoever. 

Any ideas what's happening?

I know it's in Danish, but I guess you get the point - I can translate if needed.

 

I have the same question (0)
  • eetuRobo Profile Picture
    4,204 Super User 2025 Season 2 on at

    Can you show screenshot of the Power Automate Desktop flow? Are you sure your flows logic is correct and it just goes to the end of the flow and thats why it never gives error?
    Seems like in the second picture you cancelled the flow when it was waiting for windows (after 29s it had waited).

  • PerN1 Profile Picture
    18 on at

    "Seems like in the second picture you cancelled the flow when it was waiting for windows (after 29s it had waited)."

    No, then it would say Cancelled in status instead of Succeeded.

  • eetuRobo Profile Picture
    4,204 Super User 2025 Season 2 on at

    @PerN1 wrote:

    No, then it would say Cancelled in status instead of Succeeded.



    But it does doesn't it?
    I meant the picture named: Document preview of Skærmbillede 2024-05-29 132359.png

    eetuRobo_0-1716984312250.png


    And I meant can you give more over all view of the flow. Not just single actions opened in edit. 
    Are you using on block error in your flow?

  • PerN1 Profile Picture
    18 on at

    Yes, I use a block error. Therefore the actions to follow should appear in the log, but they don't.

  • eetuRobo Profile Picture
    4,204 Super User 2025 Season 2 on at

    Not necessarily. If your error block is set up to Go to end of block it will skip any following action and go to the end when it encounters an error.

    eetuRobo_0-1716985107513.png

    So check that your on block error is set up correctly.

    It should show the End action though so this might not be the solution. If you can show more of your flow.

  • PerN1 Profile Picture
    18 on at

    I agree. And the actions after the block will show in the log. They don't.

  • PerN1 Profile Picture
    18 on at

    The action says cancelled - the process says Succeeded. Look in the upper right corner.

  • Verified answer
    PerN1 Profile Picture
    18 on at

    Well, there was a time out set in the call in the cloud flow. 😅

    Sorry guys.

Under review

Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.

Helpful resources

Quick Links

Forum hierarchy changes are complete!

In our never-ending quest to improve we are simplifying the forum hierarchy…

Ajay Kumar Gannamaneni – Community Spotlight

We are honored to recognize Ajay Kumar Gannamaneni as our Community Spotlight for December…

Leaderboard > Power Automate

#1
Michael E. Gernaey Profile Picture

Michael E. Gernaey 538 Super User 2025 Season 2

#2
Tomac Profile Picture

Tomac 405 Moderator

#3
abm abm Profile Picture

abm abm 252 Most Valuable Professional

Last 30 days Overall leaderboard