Answered

Flow isn't triggering on Microsoft form submission

(0) Share

Report

Posted on by Natso

I made a simple flow that would trigger whenever someone would submit a response to a Microsoft form. For the next step, Outlook would send an email to notify the form owners that the form has a new submission. However, the flow doesn't run at all because the form submission step isn't being triggered. I just selected the form from the dropdown. I don't understand what's causing the issue. I looked at the flow history, and despite submitting test answers to the form, automate says the form hasn't been run at all. The flow is on. Could someone help? Thanks.

The first two steps are on the left, and the last step is on the right.

Categories:

General topics

I have the same question (0)

All responses (2)

Answers (1)

RyanSummers 26 on at

Like (0)

Report

Dumb question, but is it the right survey? That's the only thing I could see as an issue in this one, my flows for forms are set up the same way. If you go to the flow runs page, in the upper right, you can click on All Runs and change the dropdown to look at checks, failed checks, etc., and see if anything ran there that you don't see on the flow runs page. It might give you some clues to start chasing down.

Was this reply helpful? Yes No
Verified answer

Natso 67 on at

Like (1)

Report

I solved it. I followed the steps in this tutorial: tutorial

Was this reply helpful? Yes No