Custom connector not using Host URL

(0) Share

Report

Posted on by CG-20111506-0

I have a custom connector created using API authentication, but when I test it does not use the Host URL that I specified. Has anyone else had this issue?

Categories:

Connector development

I have the same question (0)

All responses (2)

Answers (0)

Sven4 203 on at

Like (0)

Report

this post is a bit older but i have the same problem today. did you find a solution back then @CG-20111506-0?

Was this reply helpful? Yes No
Suggested answer

Sven4 203 on at

Like (0)

Report

If anyone else comes across this post, here is the answer.

If everything is configured correctly, unfortunately the Host Url is not displayed in the request field but always an MS Url. And yet the Host URL is used to retrieve data from the API. It is therefore important to configure everything correctly and not to be confused by the displayed URL in the test request field. After I had done this, correct host, which is displayed under Definition, the correct API key and the correct magic words (keywords), then everything works fine.

Was this reply helpful? Yes No