Recently, I have been working with automatic flows and dataflows from Power Apps, I want to use parameters for the "when a dataflow refresh completes" action. But when I check the required entries, I see that the group is: Environment Id + something (looks like region).
The When a dataflow refreshes completes trigger has three required input parameters.
Group Type: Select Environment if the dataflow is stored in a Dataverse Environment. Select Workspace if the dataflow is stored in a Power BI Workspace.
Group: This shows all the available environments/workspaces depending on the Group Type. Select the environment/workspace where the dataflow lives.
Dataflow: This shows all the available dataflows inside the environment/workspace. Select the desired dataflow for the Power Automate flow.
All the parameters are dropdowns. If you are not seeing any options to select make sure you click on the x mark at the end of the input parameter to activate the dropdown menu. The X icon turns into a chevron pointing down.
When using custom value to enter the group, the expected value populated as following: environment id-region.
These values can be retrieved from the Power Platform Admin Centre by following these steps:
In the Details section you will find the Envrionment ID value.
In the Details section header click on See all
Here you will find the region.
Hope this helps and good luck!
1 people found this reply helpful.
Was this reply helpful?YesNo
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
when.png
Share
Report
All responses (
Answers (
125
