Unanswered

How to end a flow

(0) Share

Report

Posted on by mj4golf

I have a flow that checks if a certain person creates an event. If it is, I want the flow to end. I don't see any action that allows me to do that, or is there?

Categories:

Building flows

I have the same question (0)

All responses (5)

Answers (1)

v-micsh-msft on at

Like (0)

Report

Hi @mj4golf,

Could you please share your flow configuration here?

How do you configure the checks in your flow?

You may take a look at the do until action, in the following article:

https://flow.microsoft.com/en-us/documentation/common-data-model-approve/

If you added the check into an Apply to Each, then tehre is no way to end the flow until the Apply to each finished.

Regards,

Michael

Was this reply helpful? Yes No
Verified answer

efialtes 350 on at

Like (6)

Report

@mj4golf
There is an action called Control-Terminate
https://powerusers.microsoft.com/t5/Flow-Ideas/Stop-Command/idi-p/39287

Hope this helps

Was this reply helpful? Yes No
Community Power Pla... on at

Like (3)

Report

"If you added the check into an Apply to Each, then tehre is no way to end the flow until the Apply to each finished."

Ugh. Come on MS. How hard is it to terminate a workflow.

Was this reply helpful? Yes No
markcms 28 on at

Like (0)

Report

You can use Do Until loop (aka while loop) until your condition is met, or add a condition as the first action in the foreach to skip if the condition is met (this will mean the loop continues, but does nothing).

Was this reply helpful? Yes No
Community Power Pla... on at

Like (2)

Report

Acces to the link is denied for me, could you share the content here?

Was this reply helpful? Yes No