web

You’re offline. This is a read only version of the page.

Power Platform CommunityForums Power Automate How do I rejoin the pa...

Power Automate

Answered

How do I rejoin the parallel together ??

(0) Share

Report

Report

Posted on by martinav

3,340

If I "Create Action", it joins it below, but I cannot drag the other stuff below it. Can I?

Categories:

I have the same question (0)

All responses Img

All responses (3)

Answers Img

Answers (1)

Verified answer

martinav 3,340 on at

Like (0)

Report
Copy link

Link copied!

I ended up dragging the items out of the bottom parallel set, and moving things below the first parallel set line. Then rebuild the 2nd set of parallel items. It was a little inconvenient, but I did not have to redo any actions. Good enough, I suppose.

Was this reply helpful? Yes No
MihaiR88 2 on at

Like (0)

Report
Copy link

Link copied!

In the new editor, you can go to the settings of the below action and under Run After, add the above parallel branches. This will make the lower action wait until all the parallel ones complete running.

Was this reply helpful? Yes No
martinav 3,340 on at

Like (0)

Report
Copy link

Link copied!
@MihaiR88

Its done with a union() statement... see here:

union(variables('1stQuadArray'),variables('2ndQuadArray'),variables('3rdQuadArray'),variables('4thQuadArray'))

Was this reply helpful? Yes No

Join the conversation