Unanswered

Flow/PA - no longer shows switch case when viewing run?

(1) Share

Report

Posted on by Brian-C

Hello,

I am currently trying to figure out why I can't see steps being completed in Flow all of a sudden. I have a flow that travels through a switch case, used to be I could see what was going on while it was running. Did something change?

Categories:

Using flows

I have the same question (0)

All responses (2)

Answers (0)

FaNullone 24 on at

Like (0)

Report
Copy link

Link copied!

Pstork1, I'm afraid I should disagree with you on this: I experience the same issue as the original poster - I'm unable to see steps inside my switch, even the ones which are definitely completed. I.e. I receive an email that is sent after switch has been resolved to one of the conditions - and yet I can't see any details on what steps has been completed (and I could before) - so something is definitely changed.

Was this reply helpful? Yes No
Pstork1 68,867 Most Valuable Professional on at

Like (0)

Report
Copy link

Link copied!

It depends on what you have running inside the Switch. It has always waited until an action completes before showing the action as completed. If you have multiple actions inside a Switch branch and some of them have completed while others are pending then it will show you the details of the ones that have completed.

Was this reply helpful? Yes No