There is versioning in Power Automate, but sometimes it happens that versioning doesn't show up. My best recommendation would be to duplicate your flow (just in case) so that you have a backup of the original flow.
In terms of testing, it depends on what you want to test. If you want to test everything but the Salesforce action, you can enable the 'static result' setting in the action. This will basically skip the action by providing a static result. Sometimes an output is needed. Just check the outputs checkbox and you are ready to go.
Was this reply helpful?YesNo
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
10
Share
Report
All responses (
Answers (
