Unanswered

Apply to each is too slow

(0) Share

Report

Posted on by TE-04091706-0

Hello all,

I have a flow that gets a table of images and joins them with another table of information by using their common ID value, but the time the flow is taking is not only too slow, but Power Automate itself shows that it should be taking less than half of the time to process everything

Captura de Tela (131).png

The time this part of the flow takes is just absurd, and i would like to know if there is anything i could do to make it quicker. And yes, i have set the Degree of Parallelism to 50, it takes around the same amount of time as making it run one by one. I would not changing this part of the flow, as long as it takes less time and it still joins the table of images with the second table.

Captura de Tela (132).png

Categories:

Using flows

I have the same question (0)

All responses (2)

Answers (0)

TE-04091706-0 4 on at

Like (0)

Report
Copy link

Link copied!

I have already tried that. 1, 10 or 50 it does not matter, it always take around the same time. Not even getting all of the images takes half as long as this.

Was this reply helpful? Yes No
Sundeep_Malik 6,484 on at

Like (0)

Report
Copy link

Link copied!

Hey @Raphael4
There could be better methods. But you can try this one.
Go into the settings of apply to each.
Then toggle open the option of concurrency.
And set the degree of parallelism to 50. You can decrease it to 10, 15, 20, 25 etc., according to your choice. Sometimes keeping it 50 might also decrease the performance of your flow, so keeping it low as 10 might help.
You can experiment different values and which ever gives you best results, just do that.

Was this reply helpful? Yes No