I'm experiencing an issue with my Power Automate Flow where it gets stuck in an infinite loop or responds to any word, (even if it's not part of the trigger words array) when the trigger word "one" is used.
Here's my current setup:
I have a trigger set up to listen for specific words in an incoming message (e.g., "one", "reject", "rtmate").
When the trigger word is detected, the flow is supposed to perform a series of actions.
However, when the word "one" is used, the flow goes into an infinite loop, repeating the actions indefinitely. Moreover, it also responds to any word, even if it's not part of the trigger words array.
What I've tried:
To resolve this issue, I've attempted the following:
I've tried setting a trigger condition for the trigger word step to ensure that the flow only runs when the exact word "one" is used.
I've added "one" in a separate condition to isolate the issue and see if it's specific to this word.
I've changed the trigger words from an array to a string, thinking that it might be a formatting issue.
Despite these efforts, the problem persists. I'm expecting the flow to only respond to the specific trigger words and not get stuck in an infinite loop. Has anyone else encountered this problem or have any suggestions on how to fix it?
32
Share
Report
All responses (
Answers (
