You’re offline. This is a read only version of the page.
32
Hi,
I have the following use case where my flow will the opportunity ID and update the opportunityproductid. However, once it does 1 cycle, it re-triggers the entire flow again and does an infinite infinite loop:
How can I modify the workflow so that It runs when opportunity lines are Added or Modified without doing an infinite loop ?
Thank you
You'll need to add some kind of trigger condition that will keep the flow from retriggering. There are a number of ways to do this. This article is a good introduction.
How to avoid infinite trigger loop in Power Automate (tomriha.com)
Share
Report
All responses (
Answers (
