Announcements
Hello all,
When merging two branches into one, I think I would use "New step", but "New step" is not displayed after the editing screen changes.
Could you please tell me how to solve it?
You can try switching back to Classic designer which should provide you the ability to converge the parallel branches.
@grantjenkins
Thank you for your reply.
I was able to connect it successfully using the method you taught me.
Thank you for your help.
I had the same issue so this is helpful. Do you know if Microsoft is aware / planning to fix it? Seen a few other weird issues with the new designer...not sure how I feel about it yet!
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
Congratulations to our 2026 Super Users!
Congratulations to our 2025 community superstars!
These are the community rock stars!
Stay up to date on forum activity by subscribing.
Haque 592
Valantis 340
11manish 284
