Answered

Adding additional parallel branch to a flow

(0) Share

Report

Posted on by Community Power Pla... Microsoft Employee

I have a flow that uses parallel branches to perform tasks and then rejoins to the main branch once it completes the individual parallel branches. I want to add a new parallel branch but don't get that option. See image below. I want to add a fourth parallel branch after the Set Variable action. How do I do this? As you can see the only option I have is Add an action.

Categories:

General topics

I have the same question (0)

All responses (3)

Answers (1)

Pstork1 69,024 Most Valuable Professional on at

Like (0)

Report
Copy link

Link copied!

You are in the right spot. Sometimes I've noticed that the option to add a parallel branch doesn't always popup like it should. Try clicking on another spot where you could add a branch and then go back to this one. It should give you the option.

Was this reply helpful? Yes No
Community Power Pla... Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Thanks for replying but unfortunately I have tried that numerous times and it never comes up. I have tried adding an action to the end of the flow and then going back to this point and trying to add a parallel branch and don't get that option.

Was this reply helpful? Yes No
Verified answer

Pstork1 69,024 Most Valuable Professional on at

Like (0)

Report
Copy link

Link copied!

Are you sure you are clicking the + above the branch and not the one below it? You only get the add a parallel outside of the parallel branches. The add buttons are very close, but only one will let you add a parallel branch.

Was this reply helpful? Yes No