I have not worked with Power Automate Desktop all that much and need help. I have a pop up at the beginning of my run that asks how many times the flow should run. From here, I was hoping to take that returned value and add it to my loop end. Does anyone know how I can pass the data?
First thing user developing the solution Power FX enabled flow. Power Fx is still in preview state,so i dont recommened it using in development or production.
So disable the Power Fx option while creating the flow as shown in below image.
Later start creating the flow as below shown in image.
(Note:- if you got your solution you can mark as solution and gives kudos)
Thanks & Regards
Vishnu Reddy
Was this reply helpful?YesNo
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
2
Share
Report
All responses (
Answers (
