Unanswered

Blank pdf of a power BI report is generated when exported from power automate

(0) Share

Report

Posted on by Anishsalvi

I have set of companies for which I am generating 5 reports each. I have applied an apply for each action to loop through all companies and their reports. The entire flow runs successfully generating the required pdf. But in some cases the pdf generated are blank and the same report for some companies is generated successfully. Could any body suggest a solution for the issue?

Categories:

General topics

I have the same question (0)

All responses (2)

Answers (0)

Vikas10000 8 on at

Like (2)

Report
Copy link

Link copied!

Please tell me if you fixed the issue, because I am facing similar issue, in which on export at times it shows the data but in some of the pdf it shows them blank..

Was this reply helpful? Yes No
stefanJP 24 on at

Like (0)

Report
Copy link

Link copied!
I had the same issue (but only with one report) and checking the web I learned that there are mainly 3 reasons why this would happen:
There could be an issue with the 'New Designer' mode. Turning it off makes the pdfs generate ok. (This solved my problem)
This could happen when the body of your report is too wide for the page size that you have chosen. The body of the report plus the left and right margins must be less that the page size or the content (which could just be whitespace) will be pushed to a second page.
It could be a Power platform performance issue > contact Microsoft support for help.

Was this reply helpful? Yes No