I don't have general answer for that - as it depends on slider html structure as well. So once i have automted the slider, there i have highlighted the lowest part of slider where the values are shown. so normally when clicked on those slider value- slider automatically shifts to that point - so using that logic - a dynamic selector was created which helps to move the slider across different measurements.
Was this answer helpful?
If yes, please mark it as the solution by selecting the checkbox in the discussion thread.
Your feedback motivates me to keep contributing. Thank you!
Was this reply helpful?YesNo
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
6
Share
Report
All responses (
Answers (
