I've been trying to populate a single column in my Dataverse table. From a high level, I've built a simple power automate workflow that includes AI builder (Create text with GPT using a prompt) which is triggered manually. The GPT prompt is asked to analyze a Dataverse table and provide its recommendation on a driver assignment for each specific load. Once the workflow is triggered, it starts the GPT prompt and produces an output that recommends a driver assignment based on each driver's availability. However, I'm not able to export the data that the GPT prompt outputs. Ideally, I'd like it to populate the "Finalized Driver Assignment" column in the table which I've pictured below (highlighted). The entire output of the GPT prompt is not needed, rather just that one column (highlighted in the prompt output picture). Any help would be appreciated, thanks. See below a picture of the workflow, Dataverse table, and output of the GPT prompt.
Please open the Update a Row, and grab the inputs, the raw inputs and the error message in full please.
Please dont just take pictures of the error, people cut them off all the time, can you like paste the text for the inputs, outputs and error as well as pictures please, then I should be able to help you np
Cheers,
Was this reply helpful?YesNo
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
2
Share
Report
All responses (
Answers (
