When using an iPhone 11 with the Barcode Reader control, most of the time, I am only seeing a blank screen when the camera is activated. If I use the legacy barcode scanner control, it works fine, but odd that we should need to roll back to an older control.
I have seen a few posts about this, but have not found a solution.
I would actually say its not odd... isn't that thing still in Preview.
I'm surprised it didn't destroy the phone (grumble modern controls)
Was this reply helpful?YesNo
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
674
Share
Report
All responses (
Answers (
