You’re offline. This is a read only version of the page.
Hi! I am fairly new to power automate and workflows however I have successfully set up a dataflow from dataverse which is running nicely, however I am having issues with the refresh.
I wanted to set up a simple flow to update the dataflow every half an hour, it was working fine but I am now receiving a "400" error every time the flow tries to run.
The error I am getting is:
"The backend request failed with error code '400'"
It's a really basic flow so just wondered if anyone knew what the issue might be. I have checked my permissions and log ins etc but that doesn't seem to be the issue! Any helps troubleshooting would be appreciated 🙂
Hi @leftwardsalmon,
Can you share a screenshot of the flow created, Also you may want to verify the Id's to the Dataverse table is still valid,
The Link: Dataverse
Provides further explanations on error 400 message, Kindly go through it as well to see if any applies to you.
Feel free to like my post and mark as a solution if it meets your requirement
Share
Report
1
All responses (
Answers (
