Unanswered

Apply to each is stopping my flows when I use 'Get items'

(0) Share

Report

Posted on by Community Power Pla... Microsoft Employee

Hello,

My approval flow is fine until I insert 'Get Items', then I get the Apply to each box.

What I'd like to do is use a switch control based on the info entered. I only need one item to be filtered. I noticed that things changed when I entered the dynamic data for the approvers comments to be entered in the email and I haven't been able to revert back for some reason. The other day it was all working fine.

Any help would be much appreciated, I'm going out of my mind with this one.

Categories:

Building flows

I have the same question (0)

All responses (4)

Answers (0)

ChristianAbata 8,953 Most Valuable Professional on at

Like (0)

Report
Copy link

Link copied!

Hi friend you can use filter array to get only one value from an array list.

Was this reply helpful? Yes No
Community Power Pla... Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Hi friend,

Thanks for replying.

I'm very new to flows.

So where in the process would I put this?

I want to send approval emails to different branch managers depending on the options chosen in the list. So if someone choses East branch the approval email will get sent to the East branch manager and same for the west branch.

Thanks so much.

Was this reply helpful? Yes No
ChristianAbata 8,953 Most Valuable Professional on at

Like (0)

Report
Copy link

Link copied!

You could do someting like this, so when you use filter array on a list the you have the response of all East brach in your list.

Was this reply helpful? Yes No
Community Power Pla... Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Hi,

Thanks again.

But what if I want things filtered to North, South and West managers? I was using Switch before and it was working but since I keep getting the apply to each I've given up.

Thanks so much for your help. I'm seriously stuck.

Was this reply helpful? Yes No