Build custom connector using Openapi 2.0 document with policies

(0) Share

Report

Posted on by bob53050

Hi all,

Is there a way to add policies to an Openapi 2.0 document that can be used for build a custom connector?

I found some information on the following:

Authorization header using HTTP via on-premise datagateway which I will work on to add but I wanted to check if there is a way to add this Add Header type policy to the Openapi 2.0 document.

Thanks for any help,

Bob

Categories:

Connector development

I have the same question (0)

All responses (2)

Answers (0)

thazlett Microsoft Employee on at

Like (0)

Report

Hi Bob,

Could you please provide some additional clarification? What scenario are you trying to achieve? Thanks.

Was this reply helpful? Yes No
bob53050 16 on at

Like (0)

Report

I am trying to place entries in an Openapi 2.0 document that I am building to get me as close to completion as possible as I build a custom connector from it.

This document will be used a number of times as this is a custom connector that will connect the the on-premise data gateway and then to a vendor supplied Web api.

They built it using older technology so there isn't an Openapi 2.0 document that exists for building these custom connectors.

I am check if there is Openapi 2.0 syntax that will add a policy to the custom connector for setting an Authorization header.

Thanks for your reply,

Bob

Was this reply helpful? Yes No