will power automate http request receiver trigger send 400 bad response without starting the Flow?

(0) Share

Report

Posted on by Community Power Pla... Microsoft Employee

Hi Everyone,

We have created a power automate with http request receiver trigger.

When client is sending a http request, the Flow is not starting at our end but client is receiving 400 response.

When client sends http request to power automate end point, Is there any chance that the client receives 400 response without starting the power automate?

Thanks,

Shruthi

Categories:

Using flows

I have the same question (0)

All responses (3)

Answers (0)

Sort by

StephanieAria 27 on at

Like (0)

Report
Copy link

Link copied!

Hi Shruthi,
Have you ensured that when the client sends the http request it is a POST request not a GET request?
The HTTP trigger only works with a POST request.

Was this reply helpful? Yes No
Community Power Pla... Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Hi,

Thank you for your response.

Yes, this is a POST request. It is working for most of the scenarios but in some cases, client is getting 400 response but at that time Flow is not starting from our end.
My question is "When client sends http request to power automate end point, is there any chance that the client receives 400 response without starting the power automate?

Thanks,
Shruthi

Was this reply helpful? Yes No
ajdhingr Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

@Anonymous If you ar egetting 400 error and flow is not triggering then this means the parameters passed are not correct and request is not even reaching to flows . Hope this will help . If I have answered your quest then please mark it solved.

Was this reply helpful? Yes No