Unanswered

How to exit from Apply to each (Terminate flow)

(0) Share

Report

Posted on by Sastro_Chang

Hello All ,

I have process which need to terminate (exit) because of certain condition met . Currently I have no idea on how to exit from condition (in red circle) without continuing the next process. Can anyone advice? Thanks. How to Exit from red circle without continue to next process

Categories:

General topics

I have the same question (0)

All responses (12)

Answers (0)

Gerard Simpson 2,987 Moderator on at

Like (0)

Report
Copy link

Link copied!

Hi @Sastro_Chang

If you just want to terminate without continuing once your apply to each has finished, add a 'Terminate' action under / outside the apply to each, but inside each of the 'No' branch containers.

Hope this helps - Good Luck!

Was this reply helpful? Yes No
Sastro_Chang 41 on at

Like (0)

Report
Copy link

Link copied!

Hello,
Thanks so much for your reply. I did try that before I posted this but unfortunately above that “apply to each” there is another “apply to each” whic generated automatically hence I unable to put “Termination” since it caused error said “You can’t put Termination inside apply to each”.

is there any other way?

Regards,

Was this reply helpful? Yes No
Gerard Simpson 2,987 Moderator on at

Like (0)

Report
Copy link

Link copied!

Hi @Sastro_Chang - are you saying that everything on your screen is inside a wider apply to each that is outside the extents of what you have shown in the image?

Was this reply helpful? Yes No
Sastro_Chang 41 on at

Like (0)

Report
Copy link

Link copied!

Yes, it is. I didn’t take the whole image because it will be too small.

Was this reply helpful? Yes No
VictorIvanidze 13,079 on at

Like (1)

Report
Copy link

Link copied!

Hi @Sastro_Chang,
try to use "Do until" instead of "Apply for each" - it will solve the problem completely.

Was this reply helpful? Yes No
Sastro_Chang 41 on at

Like (0)

Report
Copy link

Link copied!

Hi @VictorIvanidze

Thanks for your suggestion it was added automatically by PowerAutomate you meant I need to change it manually to “Do Until” ?

Was this reply helpful? Yes No
VictorIvanidze 13,079 on at

Like (0)

Report
Copy link

Link copied!

Yes, correct.

Was this reply helpful? Yes No
Sastro_Chang 41 on at

Like (0)

Report
Copy link

Link copied!

Thanks again. I will try and inform you.

Was this reply helpful? Yes No
Sastro_Chang 41 on at

Like (0)

Report
Copy link

Link copied!

Hi @VictorIvanidze ,

I tried to move objects to "Do until" but the "apply to each" generated automatically again. So it is useless as the "apply to each" will always be there.

Regards,
Sastro Chang

Was this reply helpful? Yes No
VictorIvanidze 13,079 on at

Like (0)

Report
Copy link

Link copied!

Why don't you just delete the automatically generated "apply to each"?

Was this reply helpful? Yes No