So I have a flow that's failed and I'm browising the run trying to figure out where it went wrong but when I try open it goes to the "classic" view and does not show the entire flow.
And when I try to open the flow run in the new mode I get an error
Do you see how the bottom brown rectangle has a grey X in the upper right corner? That means that this action did not execute. Based on the red dotted arrow, this means that you have specifically set the Configure Run After to run more than just success.
So, the top Action executed and was successful, and your Catch did not execute because it was instructed to only execute when not successful.
Feel free to elaborate, in case I've misread the tea leaves.
Was this reply helpful?YesNo
Under review
Thank you for your reply! To ensure a great experience for everyone, your content is awaiting approval by our Community Managers. Please check back later.
Share
Report
All responses (
Answers (
789
