Unanswered

Flow to invoke Oracle Stored Procedure

(0) Share

Report

Posted on by SSindhu

We have built a flow to invoke an Oracle Stored Procedure which will insert six rows into a table. We call this flow from PowerApps. We have observed that this flow works sporadically and we are not able to see a pattern. It times out very often. Is this because the connector to Oracle in is preview or are we missing something here?

Categories:

Using flows

I have the same question (0)

All responses (2)

Answers (0)

Sort by

v-yuazh-msft Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Hi @SSindhu,

Could you please share a screenshot of the configuration of your flow?

Could you please share more details about the error message when the flow run failed?

I afraid that the flow run times out because you insert too much rows,please take a try to insert only one row into the table with flow to see if the issue still exists.

Please share more details so we would try to provide a proper workaround for you.

Best regards,

Alice

Was this reply helpful? Yes No
GabrielStJohn Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Hey, @SSindhu!

Thank you for posting on the Flow Community Forum! It appears as though @v-yuazh-msft would like some more information in order to further assist you properly with your issue. Please share any additional information that was requested in order to decrease the amount of time that it will take for you to be assisted!

Thank you for being an active member of the Flow Community!

-Gabriel
Flow Community Manager

Was this reply helpful? Yes No