Hey everyone,
This has been one of the most frustrating aspects of Power Automate since I began using it pretty recently. I have an entire workflow that is comprised of six sub flows that each download a different report, and run consecutively. Whenever I have tested them all together, it works perfectly fine with no errors. However, when I want to just download one or a few specific reports, and disable a few of the other sub flows from the main page, I get this error below when the flow should be pressing a certain button or select a textbox.
Not sure why it would work perfectly fine all together, then doesn't work just a couple minutes later. What I have been doing to try to fix this is to manually change/add the UI element by going into the parameters screen, selecting the button/textbox, then going into my legacy app and clicking the button I need. This works for a little bit, but then when I want to try to run it by itself or with one or two other reports, I just get that same error again.
Please let me know if anyone knows of any solutions or workarounds to this, thank you.
