Answered

"If Image": condition doesn't work

(1) Share

Report

Posted on by mpagis

How to make condition actually work with "If Image"? My desktop flow sets variable as 'No' no matter if the image exists or not.

Categories:

Power Automate Desktop

I have the same question (0)

All responses (5)

Answers (1)

Verified answer

Nived_Nambiar 18,136 Super User 2026 Season 1 on at

Like (1)

Report
Copy link

Link copied!

Hi @mpagis

I think you need to tune the properties you have set in if image action, could you share the screenshot of if image

I have tried like below

Was this reply helpful? Yes No
mpagis 8 on at

Like (1)

Report
Copy link

Link copied!

Thank you. Did you try to add a step into the IF Image block and see that it is not being performed if the condition is "No"? I mean - if the image wasn't found in your sample?
My block steps are being performed no matter what - if the image found or not.

Was this reply helpful? Yes No
Nived_Nambiar 18,136 Super User 2026 Season 1 on at

Like (1)

Report
Copy link

Link copied!

Hi @mpagis

Yes it was going to else condition when image was not found. if image is seen, it will perform appropriate actions as well

Was this reply helpful? Yes No
mpagis 8 on at

Like (1)

Report
Copy link

Link copied!

Thank you! I change the configuration of the "IF Image" and it works now!

Was this reply helpful? Yes No
ET-25071210-0 on at

Like (1)

Report
Copy link

Link copied!

I am building an automation in MS Power Automate Desktop where the solution opens a particular contract number, selects a status from a drop down menu to route an item to a specific queue, and then clicks on submit

From there, 3 things can happen:

1. The item submits with no issues, where the process must end

2. Once the solution clicks 'submit' an error message appears.

3. Once the solution clicks 'submit' a different, bigger error appears.

In Instance 2 and 3, specific actions need to be completed when a specific error comes up. However it seems to go into the first "IF IMAGE" and finds it, completes the subsequent actions and then goes to the 2nd "If image" and doesn't move on, it just stays there? I have also tried putting the second IF Image in the first one but then it seems to go through the second IF image actions even though the second one's image wasn't found. Any ideas how I can solve?

Was this reply helpful? Yes No