Unanswered

new custom connectors definition not showing on flows

(0) Share

Report

Posted on by fdgdfgdf

I created a custom connector a long time ago, and it is working fine, however, I needed to add some new definitions to the connector, and even after updating and testing the definition on the connector side, the new actions are not showing in the flows to be used.

Categories:

Using connectors

I have the same question (0)

All responses (4)

Answers (0)

Sort by

azamarra 15 on at

Like
a
(0)

Report
Copy link

Link copied!

Can you add some picture of the flow?

Was this reply helpful? Yes No
amandalee 64 on at

Like
a
(0)

Report
Copy link

Link copied!

I have the same issue. Created a new definition in my connector but it doesn't show as an action inside the flow. I've waited a couple hours thinking its a time thing but it is still not available to be used inside flow.

Was this reply helpful? Yes No
amandalee 64 on at

Like
a
(0)

Report
Copy link

Link copied!

Posting for anyone else who gets this issue. I lodged a support request with Microsoft and waited 3 days. The issue corrected itself on the third day. Microsoft said to report the issue if it happens again.

Was this reply helpful? Yes No
DennisPreatto 39 on at

Like
a
(0)

Report
Copy link

Link copied!

Hello there,
did you make sure that the "Custom" tab was selected when searching for your connector's actions? I have no idea why but custom connectors will not appear amongst the other "premium" or "standard" connectors. You have to specifically specify that you are searching Custom connectors.

Hopefully this helps you,

have a nice day.

Was this reply helpful? Yes No