Answered

Handling Errors

(0) Share

Report

Posted on by GUser007

I have a flow that handles errors using is successful and has failed. In either case, I have a step. The flow works well and goes to either path and does what is supposed to do

However, when I check the state of the whole flow (when has failed happened for a step), the whole flow will show "Failed" anyway

Should this be happening ?

Categories:

General topics

I have the same question (0)

All responses (6)

Answers (1)

Manish Solanki 15,099 Super User 2025 Season 2 on at

Like (0)

Report
Copy link

Link copied!

Hi @GUser007

Could you pls share the screenshot(s) of flow in edit mode along with the error for failed flow?

Thanks

Was this reply helpful? Yes No
GUser007 20 on at

Like (0)

Report
Copy link

Link copied!

This is the main screen
This is the error handling
I noticed that even though the error handling handles the error the "For each" still shows an error

Was this reply helpful? Yes No
GUser007 20 on at

Like (0)

Report
Copy link

Link copied!

Any suggestions? So my flow has a action A that either fail or is successful (they are both valid states). I have dependent actions B and C for either options. However there overall flow shows failed if the action A failed even though action B or C where successful

Was this reply helpful? Yes No
Verified answer

VictorIvanidze 13,079 on at

Like (0)

Report
Copy link

Link copied!

Add a placeholder Compose action to the very end of the flow and set "Configure run after" there.

Was this reply helpful? Yes No
GUser007 20 on at

Like (0)

Report
Copy link

Link copied!

Thanks that worked - a little more detail here

Was this reply helpful? Yes No
VictorIvanidze 13,079 on at

Like (0)

Report
Copy link

Link copied!

Great. Then mark it as a solution.

Was this reply helpful? Yes No