Unanswered

Latest version Power Automate Stored Procedure "There is no available content" passing parameter problem.

(0) Share

Report

Posted on by aytactaskiran

Hi,

While using power automate stored procedure It was ok to pass parameters by choosing "Ask in Powerapps". But after latest version of Power Automate I could not pass parameters for stored procedures.

It does not seem "Ask in Powerapps" term among the dynamic contents. You can see below.

Categories:

Building Power Apps

I have the same question (0)

All responses (4)

Answers (0)

Sundeep_Malik 6,484 on at

Like (0)

Report

Hey @aytactaskiran

I would suggest you to use classic designer for this.

The new designer is a little buggy and does not have all the features right now. So I would suggest you to use the classic designer for this.

To switch back to classic designer just watch the below video:

https://www.youtube.com/watch?v=lU9L3k7ZW2c

I hope this helps 🙂

Was this reply helpful? Yes No
aytactaskiran 22 on at

Like (0)

Report

Hi @Sundeep_Malik,
Thank you so much for your quick reply. Thanks to you I could switch back to classic designer mode.

But for passing parameters I guess I have to use PowerApps instead of PowerApss V2 version.
Unfortunately I could not find PowerApps module amongst the items.

Do you have any idea to deal with this problem.

Was this reply helpful? Yes No
Sundeep_Malik 6,484 on at

Like (0)

Report

@aytactaskiran

For Passing parameters I prefer Power Apps V2 version only. I find it better than V1 in most of the cases.

Many time I have received error in V1 version so I prefer using V2 only.

I would suggest you the following videos how to use V2:

https://www.youtube.com/watch?v=vpjf5mD-COs

https://www.youtube.com/watch?v=zTViLQBkRVI

Trust me you will find V2 version really useful.

Was this reply helpful? Yes No
aytactaskiran 22 on at

Like (1)

Report

Thank you that's helped me so much.

Was this reply helpful? Yes No