The flow run successfully but didn't get any emails

(0) Share

Report

Posted on by Phitchayapha

I apply 'Send an email (V2)' and send emails to the people in the list ---> 2 times with the same template.

1st time: Send to 3 emails > Success and all 3 people in the list received emails.

2nd time: Send to around 1,000 emails > Success BUT no one received any emails.

I'm quite not sure that is the number of emails too much? How's the limitation for the number of emails? Or the issue was caused by any other reasons? How to solve this issue?

Thank you in advance for helping me.

Categories:

Using flows

I have the same question (0)

All responses (2)

Answers (0)

v-mingkz-msft Microsoft Employee on at

Like (0)

Report

Hi @Phitchayapha,
The limitation of send email(v2) is 900 emails every 60 seconds, and the PA connector has a limit of 300 API calls per 60 seconds.
The following link may help you a lot.
Solved: Sending 100's of e-mails using Flow - throttled? - Power Platform Community (microsoft.com)

Best Regards,
Kyrie

Was this reply helpful? Yes No
Phitchayapha 2 on at

Like (0)

Report

Hello @v-mingkz-msft ,

Thanks for the information.
The limitation of send email(v2) is 900 emails every 60 seconds >> This means that if I would like to send 1,000 of emails, through 'List rows present in a table' and 'send email (v2)', I have to manually send 2 times separately, right?

Thank you and best regards,
Phitchayapha

Was this reply helpful? Yes No