how to provide the inputs to call the SAP BAPI

(0) Share

Report

Posted on by amyhsieh11

Hi,

I followed this document's steps and would like to get data from SAP.

but there seems a little different between my automate and the document's.

According to that document's screen shot, it could provide inputs to call the BAPI, but in my automate, I didn't find any field that I could insert value.

. The screen shot of the document's.

. The screen shot of my automate.

Another similar scenario is I'd like to get the bank list by calling BAPI named: BAPI_BANK_GETLIST. (according to this doc.)

But, I didn't find a way to provide the Country as inputs, therefore, I get nothing from BAPI.

could anyone tell me how to provide inputs to call the SAP BAPI?

Any suggestions would be greatly appreciated!

Best regards,

Amy

Categories:

Using connectors

I have the same question (0)

All responses (2)

Answers (1)

Verified answer

Community Power Pla... on at

Like (1)

Report

You are now using SAP connector. That is using RFC and does require the installing of the Microsoft gateway and SAP RFC connector.
You could also use the Power Automate HTTP connector. That does not require any of the above. In SAP most data is exposed by HTTP. For SAP BAPI you can generate a HTTP proxy that makes the BAPI available by HTTP.

Regards

Was this reply helpful? Yes No
amyhsieh11 45 on at

Like (0)

Report

Hi @Anonymous

Thanks for your suggestion. 🙂

Was this reply helpful? Yes No