Hovering over an item doesnt show code anymorre only the name of the item

(3) Share

Report

Posted on by GJ-15050611-0

Previously, if I hovered my mouse over an element in the flow editor (New Designer mode), I could see its code, but now I only see its name in the pop-up box. Is this a new "feature"? However, in the old version, I can still see the code. But to edit this code, it doesnt appear in the Expression box. Which was previously working. Do anybody know something about this? I tried to make a picture about it.

Categories:

Building flows

I have the same question (0)

All responses (5)

Answers (0)

Suggested answer

Michael E. Gernaey 53,442 Super User 2025 Season 2 on at

Like (0)

Report

Hi @GJ-15050611-0

Your picture isn't going to come through, can you just paste a couple in instead of attach :-)

Thanks!

Was this reply helpful? Yes No
GJ-15050611-0 11 on at

Like (0)

Report

Sorry, this is my first post. I hope you can see the issue.

Was this reply helpful? Yes No
BrendanMeyerANU 8 on at

Like (1)

Report

I am having this issue too. I am unable to tell which "Body" is being used for the item/variable. It used to show it. Will need to use the old editor until it is fixed. :(

Was this reply helpful? Yes No
GJ-15050611-0 11 on at

Like (0)

Report

Hi! I wonder if Microsoft will fix this issue at all. I don't know if this forum is the one to report bugs found. Which forum to report the complaint to and that it would be good if it was fixed?

Was this reply helpful? Yes No
rzaneti 4,249 Super User 2025 Season 2 on at

Like (1)

Report

Hi,

It sounds like a "new feature" (a terrible one, I would say). Hopefully they will roll back, since everyone is complaining about. For now, my recommendation is to share your feedback to Microsoft.

Was this reply helpful? Yes No