Unanswered

All condition checks return TRUE but the final AND result is FALSE

(0) Share

Report

Posted on by Joanarrosa

I'm stuck with a strange issue in Power Automate.

I have a Condition action where I use an AND block with multiple comparisons.
When I run the flow in test mode, every single line inside the AND shows True, but the final outcome of the condition is False.

Has anyone experienced this before?
Is this a bug, a type mismatch, or something else I'm missing?

Any help is appreciated!

Categories:

General topics

all-condition-che...

I have the same question (0)

All responses (2)

Answers (0)

André Arnaud de Cal... 209 on at

Like (0)

Report

All condition checks return TRUE but the final AND result is FALSE

Hi Joanarrosa,

I have not seen this, but did not have 5 comparisons in a single condition before. My maximum was 3. Have you checked what happens if you remove one or two comparisons and then add them again?

Was this reply helpful? Yes No
Suggested answer

S-Venkadesh 876 Moderator on at

Like (0)

Report

All condition checks return TRUE but the final AND result is FALSE

Hi @Joanarrosa,

This looks like a bug where each condition is evaluated incorrectly. I assume it's being evaluated wrong at each condition level: everything shows true, but the final result still ends up false.
I ran a small test with five conditions and it behaved as expected on my side (see screenshot).
To troubleshoot, test the conditions one at a time and verify the result for each step.

I hope this information helps! If it does, please consider giving a 👍.
Best regards,
S-Venkadesh

Was this reply helpful? Yes No