Power Platform Community Forum Thread Details

I've created a new PCF control by running the following command: `pac pcf init`. I then run `npm install`.

I have not changed anything, but when I try to build the PCF control using `npm run build` I get an error:

"Failed to load config "standard" to extend from."

It appears this is an ES Lint error. I feel like the template should just "work" OOB without any modification. Am I doing something wrong?

pcf error.jpg

I think I've updated to the most recent version of the Pac CLI at 1.29.11.

Categories:

PCF control created from template does not build