Unanswered

Tools > Agent Flow not showing up

(1) Share

Report

Posted on by RJ-18041328-0

Hi,

When creating a "New Tool > Agent Flow" and saving a draft it doesn't show on my list of Tools. So I made it again that time publishing the flow, but again it didn't show up.

That image is just to show the Tools window and how I am creating the Agent Flow

Any ideas why it's happening?

Thanks

Renato

Categories:

Autonomous agents

I have the same question (1)

All responses (3)

Answers (0)

Sort by

RJ-18041328-0 54 on at

Like (0)

Report
Copy link

Link copied!

To continue with the post, I can see the flows in the section "My Flows", I renamed the published one but even though it's not showing

Was this reply helpful? Yes No
RJ-18041328-0 54 on at

Like (0)

Report
Copy link

Link copied!

I guess its because the flows didn't have any actions inside, it only had the inputs for the trigger.

I just did a new one with a simple action and it showed correctly, thanks

Was this reply helpful? Yes No
Michael E. Gernaey 53,963 Moderator on at

Like (0)

Report
Copy link

Link copied!

Hi @Community member

There is a difference between a tool and a flow so they are not equal.

A tool is a single action that a Connector has that you can simply call, like a function in C/C++/C#/F# you get the point.

A flow even an Agent flow, is a group of actions based on some type of trigger.

So not to confuse it but there is more

1. Tool <== re-useable singular thing you do (like send an email)

2. An Agent Flow <== exists inside of the agent, has a few limitations and requires a trigger and some actions

3. Power Automate Flow (Skill) <== this is built completely in the full PA UI and is connected via the Skill for an Agent running a Flow and it is part of the solution of the agent.

Was this reply helpful? Yes No