Updating PCF component

(0) Share

Report

Posted on by Community Power Pla...

Hello,

After creating my PCF control, I run the command below to generate my zip file and upload the zip file into my instance. However, if I make changes to my control what are the steps I need to follow in order to update the component? In my case, I just ran the msbuild commands and did another import from the solution interface. However after that I notice none of the javascript changes appear in the component. Was wondering if there's any documentation about doing this.

Run the command pac solution init --publisherName someName --customizationPrefix someSolutionPrefix.
Run the command pac solution add-reference --path provide path of control project folder where the pcf.proj is available.
Run the command msbuild /t:restore.
Run the command msbuild.

All responses (2)

Answers (1)

Trinity365 38 on at

Like (0)

Report

Re: Updating PCF component

Can you please add link where you get solution? I am facing same issue
Verified answer

Community Power Pla... on at

Like (0)

Report

Re: Updating PCF component

Never mind someone already asked this question. Sorry about that.