Unanswered

Sharepoint list and column scope, unable to get value to appear in power apps.

(0) Share

Report

Posted on by TK-05051441-0

Using sharepoint list as a data source for Power apps. Trying to display the value of column Part #. The column show up as 'Part #' and states "The formula uses scope, which is not presently supported for evaluation. The column was originally a single line of text and now has been swapped over to Choice type. Current ThisItem.'Part #' show nothing and give above message on scope.

Categories:

Building Power Apps

I have the same question (0)

All responses (2)

Answers (0)

victorcp 2,350 Moderator on at

Like (0)

Report
Hi,
This message appear when there is a reference to a table or an item, for ex.
If you are trying to see the value of a label in a gallery, it will prompt that message, because the label refer to gallery scope.

So, if you want to see the value of a column in SharePoint I suggest creating a label and set its text as:
LookUp( SharePoint_List, // replace with your sharepoint list ID = 1231 // replace with the item ID ).SharePoint_Column // Replace with the sharepoint column

I hope it helps 🙂

Was this reply helpful? Yes No
TK-05051441-0 2 on at

Like (0)

Report

Image attached show the gallery field where label with text ThisItem.'Part #'. Nothing shows up when column type is "Choice". Column type is switched to Single Line of text it show correctly. The type needs to be a choice and not single line. Also why is part # in parentheses? Still a noob here. Tks

2023-03-09_07-59-...

Was this reply helpful? Yes No