Update From Address in email in Powerapps

(0) Share

Report

Posted on by Kumar9024021

195

I have a powerapp where it sends email using below command.

Office365Outlook.SendEmail("ToAddress","Subject","Body");

My email address is taken as the default from address. May I know is there a way to update the From Address in this command to other Office365Group address, so that my Sentitems is not occupied fully.

Categories:

Building Power Apps

I have the same question (0)

All responses (2)

Answers (0)

Kumar9024021 195 on at

Like (0)

Report

I included the From parameter in the command, however it says 'I am not authorized to send on behalf of other email address".

Was this reply helpful? Yes No
v-siky-msft on at

Like (0)

Report

Hi @Kumar9024021
Office365 Outlook connector only support to send email as the distribution group, or on behalf of the group, Users have to been assigned "Send as" or "Send on behalf of" permission for that mailbox firstly.
Reference: Send an email , Send email as a distribution list in Office 365
Best regards,
Sik

Was this reply helpful? Yes No