Unanswered

HTML code not being send to Power Automate

(0) Share

Report

Posted on by Community Power Pla... Microsoft Employee

Hi All,

I have created an option to convert data from PowerApps HTML into a PDF document using the OneDrive option in flow. This seemed to be working fine, until today where some users mentioned that they were receiving a blank document with "Show your HTML text here."

I'm not sure how this is possible as there is always something in my html input and and would of expected anything else but that.

Part of my html input

This is what gets sent to the flow:

I assume the problem is with PowerApps rather than with flow as it doesn't seem to be sending over the correct data. However, I've not had much luck troubleshooting this issue and was wondering if anyone else has ran into this issue before?

Thank you

Categories:

Building Power Apps

I have the same question (0)

All responses (2)

Answers (0)

Sort by

Mink21 158 on at

Like (0)

Report
Copy link

Link copied!

Hi @Anonymous
Are all the users facing the same issue? Has anyone been able to create the correct document since the issue was reported?

Was this reply helpful? Yes No
Community Power Pla... Microsoft Employee on at

Like (0)

Report
Copy link

Link copied!

Hi @Mink21,

It seem that most users are facing this issue but it looks to be random and a intermittent for them sometimes it works fine other time the issue comes up. I've never seen the issue personally when testing the solution, so cant seem to replicate it.

Was this reply helpful? Yes No