Hey there,
I'm currently working on a portal for clients to see, approve and download their invoices.
Since we work in business Central, I ended up using the Dataverse connector.
But I'm stuck on an error 500, I will outline the steps I took to get to this point to maybe give a better explanation.
Note: this was all tested on a trial e3 account.
Step 1
Set up the dataverse connector inside business central using "Dataverse connection "setup".
Step 2
make the needed tables available, by setting visible to "yes".
Step 3
Make a new website in power pages and check if the tables are available and have data.
Step 4
Add the table into a page view.
Step 5
Apply the permissions.
Step 6 - The problem
Now when i try to show this in the live preview i get this error, and when i open the developer options it says "error 500" which after looking up means "any error we have no clue about" (i think).
I'm at a bit of a loss and any help is greatly appreciated, if there's something i did not explain properly i will try my best to explain better.
Thank you so much in advance!
